C1500 Pitman Arm Torque Specs. Make sure the seal is on the stud. i think if we make a thread for gmt400 torque specs it could be very useful for reference. ^ tighten j 29193 or j 29194 to 62 nm (48 lbs. I've searched the forum but can't find the torque specs. i found out a 33 or 35 mm socket fits on the pitman nut. i couldn't find any torque spec's for ball joints or tie rods in the shop manual, assembly manual, or a later year. so i changed the following parts and according to chilton's manual they recommend the following torque values: Just add any that you know. i've yet to get a factory service manual and was wodering if someone would be kind enough to supply me with some. Ft.) to seat the tapers. I was able to change mine,. you can't fit the pitman arm puller on the pitman arm with it in place, it will hit the frame and you can't get a wrench on it. relay rod (14) to the pitman arm ball stud (5).
from www.amazon.com
Make sure the seal is on the stud. relay rod (14) to the pitman arm ball stud (5). Ft.) to seat the tapers. ^ tighten j 29193 or j 29194 to 62 nm (48 lbs. I was able to change mine,. I've searched the forum but can't find the torque specs. i couldn't find any torque spec's for ball joints or tie rods in the shop manual, assembly manual, or a later year. you can't fit the pitman arm puller on the pitman arm with it in place, it will hit the frame and you can't get a wrench on it. i found out a 33 or 35 mm socket fits on the pitman nut. so i changed the following parts and according to chilton's manual they recommend the following torque values:
DJGAA 2Pcs Pitman & Idler Arms, K6143 Pitman Arm for
C1500 Pitman Arm Torque Specs i found out a 33 or 35 mm socket fits on the pitman nut. so i changed the following parts and according to chilton's manual they recommend the following torque values: I was able to change mine,. i found out a 33 or 35 mm socket fits on the pitman nut. i think if we make a thread for gmt400 torque specs it could be very useful for reference. you can't fit the pitman arm puller on the pitman arm with it in place, it will hit the frame and you can't get a wrench on it. Just add any that you know. Make sure the seal is on the stud. i've yet to get a factory service manual and was wodering if someone would be kind enough to supply me with some. I've searched the forum but can't find the torque specs. Ft.) to seat the tapers. i couldn't find any torque spec's for ball joints or tie rods in the shop manual, assembly manual, or a later year. relay rod (14) to the pitman arm ball stud (5). ^ tighten j 29193 or j 29194 to 62 nm (48 lbs.
